Toyota 30 Series Manual page 18

Point Operations
[Point 11
Reassembly:
Apply sealing agent (Three Bond's No.1217C or the equiva-
lent) on the mating surfaces of the differential cover and
housing before reassembly.
[Point 21
Inspection:
Measure the ring gear backlash.
Standard: 0.2 0.3 mm (0.008
[Point 31
Disassembly:
Put match marks on the bearing cap and differential hous-
ing.
Reassembly:
Install the adjusting nuts and bearing cap.
2. Install the bearing cap by aligning the match marks and
temporarily tighten the set bolt.
T
1 9 . 6
3. Set the dial gauge in the thrust direction of the differential
case.
4. Use the SST and tighten until the thrust clearance is elimi-
nated.
SST 09630-1 01 10-71
5. Tighten adjusting nuts on both sides by one notch each.
6. Set the dial gauge vertical to the ring gear tooth surface,
and measure the backlash.
Standard: 0.2 0.3 mm (0.008
0.012 in)
4 . 5
0.012 in)