Maintenance; Safety Instructions; General Recommendations For Ventilation System Maintenance; Cover Opening - Salda Smarty 2XV 1.1 Mounting And Installation Instruction

6. MAINTENANCE

6.1.

SAFETY INSTRUCTIONS

Unplug the unit from the mains before opening the door (disconnect the power plug from the outlet or in case a two-pole au-
tomatic circuit breaker installed, disconnect it as well. Make sure that it cannot be turned on by third parties) and wait until the
fans completely stop (for about 2 min.).
6.2.

GENERAL RECOMMENDATIONS FOR VENTILATION SYSTEM MAINTENANCE

In order to ensure proper functioning of the system, maintenance requirements and its periods should be observed. Otherwise, the warranty shall
be void. Some recommendations are provided in the table below, but they are just advisory, as the need for system maintenance depends on the
location of the unit installation, the pollution of atmosphere, population, working hours, etc.
COMPONENT
Filters
Fans
Plate Heat exchanger
Control panel
Electric heater
Presure senssor
Temperature senssor
Air intake and discharge system
Air duct system
Dampers, diffusers, grid
Switching unit (contactor)
Condensate trap and discharge
assembly
6.3.

COVER OPENING

Figure 6.3.1. Smarty 2XV
SMARTY XV v2020.3
DURING START-UP
Check the cleanliness of the filters
Check the connections and the
direction of rotation
Check the cleanliness of the heat
exchanger
Check the connections
Check the connections
Check electrical connections
Check electrical connections
Check the connections
Check the tightness
Check the tightness of connections
Check the condensate discharge
assembly and make sure that wa-
ter runs from the bath properly.
AT LEAST EVERY 6 MONTHS
Replace filters every 3 to 4 months or according to the control
device indications.
Check cleanliness. Clean, if necessary
Make sure that the impellers are not unbalanced.
Make sure that the impellers do not cause noise when rotated by
hand.
Make sure that the fastening screws are not loose and free of
mechanical damage.
Check electrical connections and make sure that these are se-
cured properly and are free of signs of corrosion.
Check cleanliness and clean, if necessary
Check the connections
Clean off dust, and check the electrical components and connec-
tions of the heater
Check the operation
Check the operation and tune up, if necessary
Clean
Clean
Clean
Every 3 to 4 months, visually assess the functioning of the switch-
ing unit (contactor), i.e. make sure that its casing has no signs
of melting or is not thermally damaged otherwise and does not
produce any unusual sounds. All the contactors in the product or
in its accessories must be checked.
Clean
Figure 6.3.2. Smarty 3XV/4XV F2
EN | 15