• Proceed to maintenance and repair after any rotation in the fan stopped.
• Clean the heat exchanger once a year.
• Firstly take out heat exchanger cassette carefully. Submerge it into a bath and wash with warm soapy water (do not use soda). Then rinse it with
weak hot water stream (too strong stream can fold the plates). Place back the heat exchanger only when it is completely dry.
Figure 6.6.1. Smarty 2XV
CAUTION: the heat exchanger can not be used when the filters are removed!
6.7.
BYPASS DAMPERS AND PRE-HEATER MAINTENANCE
• If the manual protection is activated, check for a fault before pressing the RESET button. If the fault is identified after it has been rectified, press
the RESET button using a screwdriver or similar object.
• Bypass damper and pre-heater are mounted on one block. The pre-heater shall be disconnected by removing X29 connector. The bypass damp-