Evaluation Board Overview - Analog Devices MICROCONVERTER ADUC7024 Reference Manual

The ADuC7024 Evaluation board has the following features :
•
2 Layer PCB (4" X 5" Form Factor)
•
9V power supply regulated to 3.3V on board
•
4 pin UART header to connect to RS232 Interface Cable
•
20-pin standard JTAG connector
•
Demonstration Circuit
•
32.768kHz Watch Crystal to drive the PLL clock
•
ADR291 2.5V External Reference Chip
•
Reset/Download/IRQ0 Push Buttons
•
Power Indicator/General Purpose LEDs
•
Access to all ADC inputs and DAC output from external header. All device Ports are brought out
to external header pins.
•
Surface mount and through hole general purpose prototype area
THIS DOCUMENT REFERS TO THE
N :
OTES
1. All references in this document to physical orientation of components on the board are made with respect to a component
side view of the board with the prototype area appearing in the bottom of the board.
2. The board is laid out to minimize coupling between the analog and digital sections of the board. To this end, the ground
plane is split with the analog section on the left hand side and a digital plane on the right hand side of the board. The
regulated 3.3V power supply is routed directly to the digital section and is filtered before being routed into the analog
section of the board.
Rev. 1.0
ADuC7024 Evaluation Board Reference Guide
(1) E
VALUATION
M C
ICRO ONVERTER
Page 3 of 15
B O
OARD VERVIEW
AD C7024 B
U EVAL

(1) Evaluation Board Overview

B1
OARD REV
Analog Devices Inc., MicroConverter
www.analog.com/microconverter
