3Com EtherLink 3C509B User Manual page 99

Using the Configuration and Diagnostic Program A-7
Manually, from the root directory of the EtherDisk
diskette, by typing:
3C5X9CFG [command keyword] [parameter list]
where 3C5X9CFG represents the Configuration and
Diagnostic Program name. Command keywords and
parameters shown in brackets are optional.
Table A-3 is a brief list of the command keywords and
their definitions. If you type a command keyword, each
command has parameters that you need to specify.
To configure and test the EtherLink III adapters from the
command line, follow these steps:
1. Exit the Configuration and Diagnostic Program.
2. At the system prompt for the drive containing the
Configuration and Diagnostic Program, type:
3C5X9CFG [command keyword] [parameter list]
You can get help information for specific commands such as
RUN by typing HELP, then the command. For example, at
the system prompt for the drive containing the Configuration
and Diagnostic Program, type the following and press
[Enter]:
3C5X9CFG HELP RUN
NOTE: If this computer is an operating server, notify all
users of the server to save their work and log out from the
network. The Configuration and Diagnostic Program
disrupts the normal operation of servers and workstations,
so work that is not saved may be lost.
To avoid interference from other running programs, power
down the server, and reboot with a DOS-only diskette.