3Com EtherLink 3C509B User Manual page 53

4-2 Configuring the ISA Adapter for an EISA Computer
To configure the EtherLink III ISA adapter to work in an
EISA computer, follow these steps:
1. Install the EtherLink III adapter in your EISA
computer (refer to Chapter 1 for instructions).
2. Boot your computer under DOS, version 3.1 or
later.
3. Place the EtherDisk diskette in the floppy drive on
your computer and make that drive the active drive.
For example, if the diskette drive is A, type the
following command:
A: [Enter]
4. Type at the prompt:
INSTALL [Enter]
5. The first time you use the diskette to install an
adapter, a license screen appears. To accept the
terms and conditions of the 3Com end-user
software license agreement, type the following:
Y
NOTE: To view the full text of the license agreement,
press [F1].
The auto installation screen shown in Figure 4-1 appears.
6. Read the screen and press [Enter].
7. When the main menu screen shown in Figure 4-2
appears, select Configuration/Diagnostic/
Troubleshooting and press [Enter].