Performing Troubleshooting and Diagnostic Tests 7-11
3. To change a setting in any field, follow these steps:
a. In the Group Select box, use the arrow keys to
select a test group.
NOTE: For instructions on running Group 2 or
Group 3 tests, refer to the next section, "Group 2
and Group 3 Test Setup."
b. In the Group X Tests box, use the arrow keys to
highlight a test. Press the [Space Bar] to enable
or disable an individual test.
c. In the Repetitions box, specify the number of
times you want to run the Group 1 tests, or use
the arrow keys to select the Continuous option.
d. In the Errors box, press the [Space Bar] to select
or deselect the Halt on Error parameter.
4. When you are satisfied with the new test setup,
highlight the <OK> command button and press
[Enter].
5. To run the tests, choose Run Tests from the Test
menu and select the <Start> command button.
For a description of these tests, refer to the section
"Adapter Test Setup" earlier in this chapter.