3Com EtherLink 3C509B User Manual page 45

4. Follow the on-line prompts and the instructions that
accompanied your EISA computer to run the EISA
configuration program.
NOTE: The sequence of configuration steps required for
some EISA computers may vary from the steps above.
Consult the configuration program manual provided by
the manufacturer of your computer for more details.
5. When the EISA configuration program asks for .CFG
files to copy, remove the EISA configuration diskette.
6. Insert the EtherDisk diskette.
Press [Enter], and use the following files:
!TCM5092.CFG for the 3C579-TP adapter
!TCM5093.CFG for the 3C579 adapter
CAUTION: An ISA adapter configured for an ISA computer
will work in an EISA computer. However, 3Com recommends
that it be configured for an EISA computer using the
EtherDisk Configuration and Diagnostic Program before it is
installed in an EISA computer. Refer to "Configuring the ISA
Adapter for an EISA Computer" in Chapter 4 for instructions.
7. When the adapter is configured successfully, proceed
to one of the following, depending on your situation:
a. Refer to the section "Changing Software Options
Settings" if you need to change the Network Driver
Optimization or Maximum Modem Speed settings.
b. Refer to the section "Auto Installing the EISA
Adapter for a NetWare NOS" if your environment
meets the auto installation requirements described at
the beginning of this chapter.
Configuring the EISA Adapter 3-3