C-4
Error Messages
The ConfigPort value xxxxx on the command line is not
supported. Valid settings are 100–1E0, in increments of 10.
Please try again.
The selected EtherLink III can only be configured while in test
mode. The diagnostic tests cannot be run from this mode.
The selected interrupt request level is being used by another
device installed in the computer. Do you want to save the
configuration anyway?
The selected I/O base address is being used by another device
installed in the computer. Do you want to save the configuration
anyway?
The value xxxxx at line x in the configuration file is not
supported. Check the EtherLink III Adapter Guide for
supported option settings.
The value xxxxx on the command line is not supported. Check
the EtherLink III Adapter Guide for supported option settings.
There is only one transceiver on the board. This selection cannot
be changed.
Unable to configure boot PROM base address at line x in the
configuration file. The boot PROM is disabled.
Unable to configure boot PROM base address. The boot PROM
is disabled.