General Information On Safety Regulations; Warranty Terms And Conditions - Lippert Components Project 2000 12600 Series Owner's Manual

General Information On Safety Regulations

All dangerous equipment such as shafts, pulleys, chains, crown gears, etc. have been isolated and protected - within
structural limitations - with suitable protection panels.
The aforementioned panels, which effectively protect the user against dangerous components, shall not be
removed, not even temporarily, and they shall be protected against interference throughout the bed lifting system
life.
If it is necessary to remove the protections, the operator shall however follow safety instructions in order to protect
him/herself and any other person in the operation area of the bed lifting system. Protections shall however be put
back into place as soon as the maintenance operation is finished.
More specifically, it is necessary - while performing maintenance operations - to:
• Make sure the vehicle is parked and secured in safe and stable conditions before starting maintenance
operations.
• Carry out each operation with the vehicle parked and only after disconnecting power.
• The bed lifting system must never be used while the vehicle is running.

Warranty Terms And Conditions

The Manufacturer "Project 2000" guarantees the bed lifting system components for 24 months after purchase.
Defective parts shall not be tampered with and they shall be returned together with the serial number indicated on
the plate located on the bed lifting system.
Parts that have been tampered with or partially disassembled will not be covered under warranty. Electronic control
units will not be covered under warranty in case of incorrect connection detection to the system: in this case repair
costs will be charged to the customer.
The Manufacturer "Project 2000" may decide to replace defective components instead of repairing them. Should
replacement or repair have a negative outcome, the customer can charge repair costs to the Manufacturer or cancel
the purchase.
Warranty won't be applied if the necessary periodic check ups, requested in this handbook, are not carried out and
noted.
The manufacturer will not be liable for any indirect damage.
DAMAGES CAUSED BY IMPROPER USE OF THE BED LIFTING SYSTEM, OR USE NOT IN COMPLIANCE WITH THE
INSTRUCTIONS PROVIDED IN THIS MANUAL, WILL NOT BE COVERED UNDER WARRANTY.
The warranty covers repair or replacement of parts at the Manufacturer's (Project 2000) premises. Transport costs
(for spare parts under warranty) as well as retailer labor costs or other costs required by the user are not covered
under warranty.
All disputes shall be subject to the jurisdiction of the court of Florence (Italy).
Page 17
Rev: 11.21.2014 Euro Loft Bed Lift by Project 2000 Owner's Manual