3Com 3102 User Manual page 52

52 C 5: S
HAPTER TANDARD
F
EATURES
enter a * if a pause is required between an access code and a destination
number.
The number that you choose may be limited by your call permissions. To
view your permissions, see NBX NetSet > User Information > Call
Permissions.
From the telephone, you can set call forwarding using feature codes. Use
the NetSet utility to see your call forwarding settings. Your administrator
can also set programmable access buttons for call forwarding. And you
can select Call Forward All directly from the display panel.
Forward to Mail
From the telephone, you can set your 3Com Telephone so that all
incoming calls go directly to your default call coverage point, usually your
voice mailbox. You can change the destination to the Auto Attendant or
receptionist or a different telephone number. This feature is referred to as
FWD MAIL, Forward to Mail, Forward All Calls to Voice Mail, and Forward
All Calls to VM. When Forward to Mail is in effect, your telephone rings
once before forwarding the call to your default call coverage point.
On a 3Com 3102 Business Telephone:
1 Press the (Forward to Mail) button. The indicator light turns on.
2 To turn off Forward to Mail, press the button again. The light turns off.
On a 3Com 1102, 2102, or 2102-IR Business Telephone:
1 Press the FWD MAIL (Forward to Mail) button. The indicator light turns
on.
2 To turn off Forward to Mail, press the button again. The light turns off.
To set your default call forwarding destination, use the NetSet utility. See
"Default" later in this section.
To prevent the telephone from ringing even once, use the Do Not Disturb
feature (see "Do Not Disturb"
feature (see "Call Forward All"
Call Forward No Answer, Call Forward Busy, and Call Forward All override
this Forward to Mail setting if they are in effect. If you turn off Forward to
Mail and no other call forward options are in effect, unanswered calls still
go to your default call coverage point but after the number of rings
specified in NBX NetSet > User Information > Call Forward Default.
in Chapter 6) or use the Call Forward All
later in this section).