Table of Contents
Advertisement
Location and Function
of Parts
1 2
3
8
9
A
12 V (DC power input) connector
Connect to an AC adapter (not supplied).
Note
For details about supported AC adapters, contact
your distributor. Use of other AC adapters may
cause a fire or malfunction.
B
LAN (network) connector (RJ-45)
Connect to a 10BASE-T, 100BASE-TX, or
1000BASE-T switching hub using a LAN cable (not
supplied, category 5 or higher, shielded twisted
pair).
Notes
• For safety, do not connect the connector for
peripheral device wiring that might have
excessive voltage to this port. Follow the
instructions for this port.
• When connecting this product to a network,
connect via a system that provides a protection
function, such as a router or firewall. If connected
without such protection, security issues may
occur.
C EXTERNAL connector
Note
Not supported in the current software version.
4 5 6
7
9
0
D HDMI OUT 1/HDMI OUT 2 connectors
Connect to the HDMI input connectors of a display,
projector, or other video device to display the output
video from the unit.
E STATUS button/LED
Press and hold the button for 5 seconds with the unit
turned so that the POWER LED starts flashing
green. Press and hold the POWER button for
3 seconds while the LED is flashing to restart the
unit and restore all settings, including network
settings, to their factory default settings.
Lights in green when the unit is operating normally.
Lights in red when not connected to the network.
Flashes in red when an error (such as an over-
temperature alarm) occurs in the unit.
F POWER button/LED
Power is supplied and the POWER LED lights in
green when the unit is connected to an outlet using
an AC adapter (not supplied) and power cord.
To turn the unit off, press and hold the button for
3 seconds. The POWER LED goes out when the
unit turns off.
To turn the unit on again, press the POWER button.
The POWER LED lights in green.
In standby state, the power LED lights in orange.
For details about switching to standby state, see
"[Standby]" (page 26).
G HDMI IN 1/HDMI IN 2 connectors
Connect to the HDMI output connectors of a
camera, computer, or other video device.
H MIC IN connector
Connect to the audio output connector of an audio
device.
I Mounting screw holes (four locations on
bottom panel)
Use to mount the unit.
For details, see "Mounting using mounting screws"
(page 10).
J Ratings label (bottom panel)
Important
This label shows the name of the unit and its
electrical ratings.
6
Advertisement
Table of Contents
