Running The Chroma Key-Less Cg Overlay Application - Sony REA-C1000 Operating Instructions Manual

9
When finished, click the [Next] button.
The following setup screen appears.
10
Move the blue circles to change the size of
the P-in-P display, and drag the blue frame
to adjust the position.
The diagram below shows an example
configuration.
Clicking the [Reset] button will reset the P-in-P
display position/size and [Input 1 Transparency] to
their defaults.
11
Change the transparency of the image in
[Input 1 Transparency].
12
When finished, click the [Next] button.
The following setup screen appears.
13
To display the foreground, place a check
mark in [Show Foreground Object].
The foreground image is displayed in front of the
output image.
14
Move the purple circles to change the
display size of the foreground image, and
drag the purple frame to adjust the position.
The display size changes while maintaining its
aspect ratio.
Tips
• Only one foreground image can be stored on the
unit. To change the foreground image, click the
[Browse] button and select the image file to be
registered as the foreground image on the
displayed screen.
An image file in the following format can be
registered.
– File format: PNG
– File size: 50 MB or smaller
– Picture size (H×V pixels): 3840×2160 (max),
30×30 (min)
Scaling in the range 16 times to 1/16 times the
original image is supported.
• The foreground image is saved in the unit. To
delete it, restore the factory settings (page 26).
15
When finished, click the [Done] button.
The setup is saved in the unit.
Running the Chroma key-less CG
Overlay application
Run this application to create CG composite images
without the need for a dedicated studio.
1
Select [Chroma key-less CG Overlay] from
[Applications].
2
Click the [Run] button.
The run screen appears.
Note
Make sure that no people appear in the image when
you click the [Run] button. Make sure that the
person you want to include in the composite image
only appears in the camera image after starting the
application.
3
Perform the following operations as
required.
[Flip Horizontally]: Flip the HDMI OUT 2
connector output and preview screen images
horizontally.
[Show Input 1]: Display only the image that is
input on the HDMI IN 1 connector on the
45