Appendix; Message List; Led Indicators; Web Browser Display - Sony REA-C1000 Operating Instructions Manual

Appendix

Message List

The following messages may appear on the unit. Perform the following as necessary.

LED indicators

LED
STATUS LED is red
STATUS LED is flashing red
POWER LED is green and STATUS LED is
off

Web browser display

Message
The device's temperature is high. Shut down
the device and wait until it has cooled off
before proceeding.
No HDMI Input Signal
There is no HDMI input signal. Correctly
connect a device with an HDMI signal.
Incorrect HDMI Input
The HDMI Input signal format is incorrect.
Switch the HDMI input signal.
Copyrighted Input
Cannot display copyrighted signals (HDCP).
Change the input signal.
License Will Expire
The license will expire soon. Please renew the
license.
The license for operating the application is
invalid. Please validate the license.
The software update has failed. Check the
software version.
Connected camera is not compatible.
Correctly set the camera's IP address and
model name in the Input/Output settings and
connect a compatible camera.
A compatible interconnecting camera is not
connected.
The composition cannot be adjusted because
tracking is not in progress. Adjust the
composition after tracking resumes.
Foreground data is broken. Please upload
again.
Meaning and solution
The unit is not connected to the network. Check the network cable connection.
A problem, such as high temperature, occurred in the unit. Turn off the unit and
allow it to cool before turning the unit on again.
If this state occurs after the unit is powered on, the unit did not start up correctly.
Disconnect the AC adapter, and then reconnect it to turn the unit on.
Meaning and solution
Power off the unit and wait until it has cooled down. Check that the temperature
has decreased before connecting the power again to start the unit.
There may not be an input device connected correctly to the HDMI IN connector.
Check the input device and its connection, then turn the unit off and then on
again.
The HDMI input signal may not be in a format supported on the unit.
Check the input signal.
An input signal protected using HDCP may have been input on HDMI IN.
Check that the input signal is not protected using HDCP.
The license for the currently active option function will expire soon. To continue
using the option function, purchase and activate a license.
An option function license required for the application has not been installed.
Activate a pre-installed license, or purchase and install a license.
Check that the software update was completed successfully or check the software
version.
An application may not function because a camera that is not compatible is
connected to the unit. Check the camera. Also, check that the camera to be
connected is configured correctly in "Input/Output" (page 14).
The camera may not be connected properly using a network cable or the camera
may be turned off. Check the connection status and power source. Also, check
that the camera to be connected is configured correctly in "Input/Output"
(page 14).
Wait until tracking resumes or return to the home position to resume.
The foreground data saved on the unit is corrupted. Upload the data again from
the Chroma key-less CG Overlay setup screen.
51