Table of Contents
Advertisement
Unit Setup (Common Settings)
This section describes the common settings of the unit
on each menu page.
This configuration is performed by the administrator.
Basic Operations in the
Common Settings Menu
Click an item in the common settings menu on the left
side of the screen to display the setup screen for that
item.
If the setup screen displays multiple tabs, click on a tab
to switch the display in the setup screen.
The following buttons at the bottom of the setup screen
are common for all items.
[OK]: Click to apply the settings. The settings are not
applied on the unit until you click this button.
[Cancel]: Click to discard the settings and return to the
previous state.
Note
Only those items that are currently configurable are
displayed. Items that are grayed out cannot be
configured. Functions that are not installed are not
displayed.
Input/Output
Use to configure the connected camera that supplies the
video input of the unit.
You can preview and adjust the video from a camera or
device connected to the HDMI IN 1 connector or HDMI
IN 2 connector.
[HDMI IN 1] / [HDMI IN 2]
Select the connector to which the camera or device
whose video you want to preview is connected.
Preview image
When a camera or other video device connected to the
HDMI IN 1 connector or HDMI IN 2 connector is
operating normally, a preview of the image from the
camera or device is displayed.
[Nickname]
Enter a nickname for the connected camera or device.
This is used as an identifier when configuring
applications.
[IP Address]
Enter the IP address of the remote camera to control a
Sony remote camera from the unit using VISCA over IP.
To clear the IP address, enter "0.0.0.0".
[Model Name]
Select the model name or enter an arbitrary model name
for the remote camera to control from the unit using
VISCA over IP.
Note
When a supported camera is connected. the following
camera functions can be controlled by the unit. For
correct camera operation, configure the [IP Address]
and [Model Name] settings.
• Pan, tilt, and zoom functions
– Control using PTZ Auto Tracking application
• Exposure and white balance functions
– Control using Handwriting Extraction application
• Tally lamp function
– Control using PTZ Auto Tracking application
– Control using Real-time Cropping application
14
Advertisement
Table of Contents
