Configuring Igmp Accounting And Authentication Features - TP-Link T2600G Series User Manual

Configuring Layer 2 Multicast
Switch(config)#show ip igmp snooping groups static
Multicast-ip
------------
239.1.2.3
Switch(config)#end
Switch#copy running-config startup-config

2.2.5 Configuring IGMP Accounting and Authentication Features

You can enable IGMP accounting and authentication according to your need. IGMP
accounting is configured globally, and IGMP authentication can be enabled on a per-port
basis.
To use these features, you need to set up a RADIUS server and configure add the RADIUS
server for the switch.
Follow these steps to add the RADIUS server and enable IGMP accounting globally:
Step 1 configure
Enter global configuration mode.
Step 2 radius-server host ip-address [ auth-port port-id ] [ acct-port port-id ] [ timeout time ] [
retransmit number ] [ nas-id nas-id ] key { [ 0 ] string | 7 encrypted-string }
Add the RADIUS server and configure the related parameters as needed.
host ip-address:
auth-port port-id:
requests. The default setting is 1812.
acct-port port-id:
requests. The default setting is 1813. Usually, it is used in the 802.1X feature.
timeout time:
resending. The valid values are from 1 to 9 seconds and the default setting is 5 seconds.
retransmit number:
does not respond. The valid values are from 1 to 3 and the default setting is 2.
nas-id nas-id:
RADIUS packets for identification. It ranges from 1 to 31 characters. The default value is the
MAC address of the switch. Generally, the NAS indicates the switch itself.
key { [ 0 ] string | 7 encrypted-string }:
type. 0 indicates that an unencrypted key will follow. 7 indicates that a symmetric encrypted
key with a fixed length will follow. By default, the encryption type is 0.
for the switch and the server, which contains 31 characters at most.
symmetric encrypted key with a fixed length, which you can copy from the configuration file of
another switch. The key or encrypted-key you configure here will be displayed in the encrypted
form.
VLAN-id Addr-type
------- ---------
2 static
Enter the IP address of the server running the RADIUS protocol.
Specify the UDP destination port on the RADIUS server for authentication
Specify the UDP destination port on the RADIUS server for accounting
Specify the time interval that the switch waits for the server to reply before
Specify the number of times a request is resent to the server if the server
Specify the name of the NAS (Network Access Server) to be contained in
Switch-port
-----------
Gi1/0/1-3
Specify the shared key. 0 and 7 represent the encryption
IGMP Snooping Configuration
string is the shared key
encrypted-string is a
User Guide 313