TP-Link T2600G Series User Manual page 169

Configuring DDM (Only for Certain Devices)
Rx Power Threshold(mW) :
Gi1/0/27
...
Switch(config-if)#end
Switch#copy running-config startup-config
■ Configuring Tx Power Threshold
Follow these steps to configure the threshold of the DDM Tx power on the specified SFP
port.
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
The following example shows how to set SFP port 1/0/27's high alarm threshold Tx power
as 6 mW.
Switch#configure
High Alarm Low Alarm
6.000000 --
configure
Enter global configuration mode.
interface { fastEthernet port | range fastEthernet port-list | gigabitEthernet port | range
gigabitEthernet port-list | ten-gigabitEthernet port | range ten-gigabitEthernet port-list }
Enter interface configuration mode.
ddm tx_power_threshold { high_alarm | high_warning | low_alarm | low_warning } value
high_alarm: Specify the high threshold for the alarm. When the operating parameter rises
above this value, action associated with the alarm will be taken.
high_warning: Specify the high threshold for the warning. When the operating parameter
rises above this value, action associated with the warning will be taken.
low_alarm: Specify the low threshold for the alarm. When the operating parameter falls
below this value, action associated with the alarm will be taken.
low_warning: Specify the low threshold for the warning. When the operating parameter falls
below this value, action associated with the warning will be taken.
value : Enter the threshold value in mW. The valid values are from 0 to 6.5535.
show ddm configuration tx_power
Display the DDM tx power threshold on the SFP ports.
end
Return to Privileged EXEC Mode.
copy running-config startup-config
Save the settings in the configuration file.
High Warning
--
DDM Configuration
Low Warning
--
User Guide 140