Table of Contents
Advertisement
Configuring Layer 2 Multicast
Port
-----------
Gi1/0/1
Gi1/0/2
Gi1/0/3
Switch(config-if-range)#end
Switch#copy running-config startup-config
3.2.4 Configuring Hosts to Statically Join a Group
Hosts or Layer 2 ports normally join multicast groups dynamically, but you can also
configure hosts to statically join a group.
Follow these steps to configure hosts to statically join a group:
Step 1
configure
Enter global configuration mode.
Step 2
ipv6 mld snooping vlan-config vlan-id-list static ip interface {fastEthernet port-list |
gigabitEthernet port-list | ten-gigabitEthernet port-list | port-channel lag-list }
vlan-id-list:
ip:
port-list
static member ports of the group.
Step 3
show ipv6 mld snooping groups static
Show the static MLD Snooping configuration.
Step 4
end
Return to privileged EXEC mode.
Step 5
copy running-config startup-config
Save the settings in the configuration file.
The following example shows how to configure port 1/0/1-3 in VLAN 2 to statically join the
multicast group FF80::1001:
Switch#configure
Switch(config)#ipv6 mld snooping vlan-config 2 static FF80::1001 interface
gigabitEthernet 1/0/1-3
Switch(config)#show ipv6 mld snooping groups static
MLD-Snooping
-------------------
enable
enable
enable
Specify the ID or the ID list of the VLAN(s).
Specify the IP address of the multicast group that the hosts want to join.
/
lag-list:
Specify the ports that is connected to the hosts. These ports will become
Fast-Leave
--------------
enable
enable
enable
MLD Snooping Configuration
User Guide
328
Hide quick links:
Advertisement
Table of Contents
