Configuring Igmp Snooping For Vlans - TP-Link T2600G Series User Manual

Configuring Layer 2 Multicast
The following example shows how to enable IGMP Snooping and header validation globally,
and specify the IGMP Snooping version as IGMPv3, the way how the switch processes
multicast streams that are sent to unknown multicast groups as discard.
Switch#configure
Switch(config)#ip igmp snooping
Switch(config)#ip igmp snooping version v3
Switch(config)#ipv6 mld snooping
Switch(config)#ip igmp snooping drop-unknown
Switch(config)#ip igmp snooping header-validation
Switch(config)#show ip igmp snooping
IGMP Snooping
IGMP Version
Unknown Multicast
Header Validation
...
Switch(config)#end
Switch#copy running-config startup-config

2.2.2 Configuring IGMP Snooping for VLANs

Before configuring IGMP Snooping for VLANs, set up the VLANs that the router ports and
the member ports are in. For details, please refer to
The switch supports configuring IGMP Snooping on a per-VLAN basis. After IGMP
Snooping is enabled globally, you also need to enable IGMP Snooping and configure the
corresponding parameters for the VLANs that the router ports and the member ports are
in.
Follow these steps to configure IGMP Snooping for VLANs:
Step 1 configure
Enter global configuration mode.
:Enable
:V3
:Discard
:Enable
Configuring 802.1Q
IGMP Snooping Configuration
VLAN.
User Guide 306