Custom Audio Electronics MODUS3 User Manual page 38

SPEED / QUALITY
PRINT WIDTH
LOW PAPER
OUTPUT MOUTH
PAPEREND BUFFER CLEAR
PRINT DENSITY
38
Setting of printing speed and printing quality:
Normal D
High Quality
Printing area width:
48 mm 54 mm
50 mm 56 mm
52 mm 58 mm
Setting the optional low paper sensor:
D
Disabled = Sensor disabled
Enabled = Sensor enabled
Setting the paper jam and output paper presence sensors on the optional bezel:
Disabled D = Sensors disabled
Enabled = Sensors enabled
Cleaning mode of the data in receive buffer, if the printing is stopped due to lack of paper:
D
Disabled = the data remain in the receive buffer. When the paper runs out, the device
keeps the remaining data in the receive buffer and prints the remaining
portion of the ticket after that the new paper is loaded.
Enabled = when the paper runs out, all data in the receive buffer are deleted.
Adjusting the printing density:
-25% 0% D +25%
-12% +12%
The print quality is strongly inluenced by the type of chemical treatment and the type
of storage to which the thermal paper has been subjected, as well as by the weight of
the same. It may therefore necessary to act on this parameter to obtain the desired
print quality.
60 mm 66 mm
62 mm 68 mm
64 mm 70 mm
72 mm 78 mm
74 mm 80 mm D
76 mm