Automatic Leveling Procedure - Lippert Components Auto Level Owner's Manual

Callout
A
B
C
D
E
F
G
H
I
J
K

Automatic Leveling Procedure

Note: Coach requires 12.75V DC to commence auto-leveling function.
Note: Refer to Component Description listing in the System Information section for questions regarding
component locations and functions of the four-point three-valve hydraulic leveling system.
Note: The engine MUSt be running and the parking brake MUSt be engaged for the four-point three-
valve hydraulic leveling system to operate.
Note: Pressing any button during an automatic sequence will stop the sequence and a "Function Aborted"
error code will occur. Press ENTER to clear the code and then continue the operation or start a new
function.
1.
Press the Power Button (Fig. 1K) to turn system on. The green light will illuminate.
2.
Press Auto Level (Fig. 1F). LCD Screen will display "Remain Still."
3.
The coach will level automatically and indicate "Auto Level - Success" in the LCD display (Fig. 1E).
Note: Display will then read "Level - Jacks: Down." Do not press any buttons until this message appears or
a "Function Aborted" error will be displayed.
Rev: 06.25.20
e
A
B
C
F
Description
Up Arrow (UP) - Scrolls up through menu on LCD.
Down Arrow (DOWN) - Scrolls down through menu on LCD.
ENTER - Activates modes and procedures indicated on LCD.
RETRACT - Places leveling system into retract mode - Manual mode ONLY.
Press and hold for several seconds to activate Auto Retract Function.
LCD Display - Displays procedures and results.
AUTO LEVEL - Places leveling system into auto level mode.
FRONT Jack Button - Activates both front jacks in manual mode.
LEFT Jack Button - Activates left rear jack in manual mode.
RIGHT Jack Button - Activates right rear jack in manual mode.
REAR Jack Button - Activates both rear jacks in manual mode.
Power Button - Turns leveling system on and off.
Fig. 1
K
G
D
H
Page 5
I
J
CCD-0001515