Automatic Safety Shutoff
The touchpad will automatically turn off after four minutes, if left inactive. To reset the system, turn the
coach ignition off, then back on. Press the touchpad's Power Button (Fig. 1K) again.
Drive Away Protection System
If the ignition is in the "RUN" position, the jacks are extended and the operator releases the parking brake,
all indicator lights will flash and the alarm beeper will activate. The leveling system will automatically fully
retract the jacks to clear the alarm, or, if the operator resets the parking brake, the alarm will shut off.
Jacks Up Verification
If the coach ignition is in the "RUN" position, the parking brake is released and the vehicle is in motion; the
leveling system may activate the power unit to ensure retract pressure is high enough to keep jacks fully
retracted. The LCD screen will say "JACKS UP VERIFICATION" until the retract pressure returns to normal
level. The touchpad will then turn off. No beeping will occur and the "JACKS DOWN" dash light will not
illuminate.
Low Voltage Signal
1.
The vehicle requires 12.75V DC to operate in the AUTO mode. If the voltage is too low, the screen will
display "Low Voltage."
2.
Minimum Voltage - If voltage drops below 9.5V DC during AUTO or MANUAL operation, "Low Voltage"
will appear in the screen and the system will cease operating.
Note: Coach will operate in manual mode between 9.5V DC and 12.75V DC.
Rev: 06.25.20
Page 9
CCD-0001515
Need help?
Do you have a question about the Auto Level and is the answer not in the manual?
Questions and answers