Connection To The Robotic Lawnmower - Husqvarna Automower 305 Technical Manual

4. AUTOCHECK EXP SERVICE PROGRAM
4.2 Connection to the robotic
lawnmower
1. Connect the service cable between your
computer and the robotic lawnmower:
• Remove the protective cover for the
battery on the bottom of the mower. The
service outlet is located under the cover,
beside the battery.
• Connect the service cable in the service
outlet. The service cable can only be
connected in one way.
2. Put the main switch on the mower in position 1.
3. Start Autocheck EXP.
Contact between Autocheck EXP and the
mower is usually established automatically
and confirmed through the mower's model
designation and serial number being entered in
the bar at the bottom of the program.
If the text Connected mower: None is displayed
in the lower bar in Autocheck EXP, contact with
the mower has not been established. If this is
the case, check the following:
• Check that cable is correctly connected both in
the computer and in the mower.
• The mower is on, i.e. main switch in position 1
and that the start page is visible.
• Make sure that G3 is selected in the program's
bottom left corner.
• If you change between mowers from
Generation 2 and Generation 3, the channel
for the respective family of mowers must be
selected. When connecting e.g. Automower
305, 308 and GARDENA R40Li, R70Li the G3
channel must therefore be selected.
IMPORTANT INFORMATION
Remember to refit the protective cover
on the battery on the mower once work
has been completed.
Autocheck EXP is closed by selecting Exit under
File, or alternatively clicking the close button in the
3020-014
window's upper right corner.
®
English - 43