GPI 03 Series Owner's Manual page 4

Quick Start
If your installation is rela tively simple
and you have installed our Electronic
Digital Meter (EDM) meters before,
you may use this section to quickly
install and operate your meter. This
section is especially helpful to those
measuring thin vis cosity fluids dis-
pensed through a hose and nozzle.
If you complete this section and
encounter difficulties, please refer to
other sections, as necessary.
NOTE: To accommodate different
installations, the faceplate can be
rotated 180 degrees. To do this,
remove the four corner screws
from the face of the meter and lift
the computer assembly from the
tur bine. Rotate the computer as-
sembly 180 degrees. Place on the
turbine ensuring the seal is fully
seated. Secure the four screws.
Connections
1. To protect against leakage, make
sure all threads are sealed with
two or three turns of thread tape
or a sealing compound compat-
ible with the liquid being metered.
(Figure 1)
4
Make sure the thread tape or
sealing compound does not
interfere with flow.
2. Make sure the arrow on the outlet
is pointing in the direction of the
flow. (Figure 2)
3. Tighten the meter onto the fittings.
Use a wrench only on metal me-
ters. Hand tighten plastic meters.
Using a wrench on plastic me-
ters could damage the meter.
Verify Meter Accuracy
Before using, you should check the
meter's accu racy and verify calibra-
tion.
Figure 1
1. Make sure there is no air in the
system by starting the flow until it
runs steadily. Then, stop the flow
using a valve or nozzle.
2. If desired, hold down DISPLAY
for 3 seconds to zero the meter's
Batch Total. When zeros appear,
release the button.
3. Verify meter accuracy before
use. To do this, measure a
known quantity of liquid into a
calibration container and compare
the volume measured against
the readout. If necessary, field
calibrate the meter. Refer to the
Calibration Section.
CAUTION
Figure 2
CAUTION