Q9 Operation - GPI 03 Series Owner's Manual

OPERATION
COMPUTER DISPLAY
All operations are revealed on the
LCD using the large 6-characters in
the top row and smaller characters
and symbols in the second row.
These characters and symbols
indicate information regarding totals,
flow, calibration, units of measure
and operational messages.
COMPUTER DISPLAY
When batteries are installed, the
computer is on continuously and
always ready to perform.
The computer is powered by field
replaceable commercially available
Figure 7
Figure 8
GENERAL
The computer maintains two totals;
Batch total and accumulative total.
The batch total can be reset to
measure flow during a single use.
The accumulative total provides
continuous measurement and
can only be reset by removing the
batteries, holding down the Display
button, and replacing the batteries.
14
Push button operation varies
dependent upon the various modes
of operation, i.e. Normal Operation
mode and Field Calibration mode.
Their operation will be described in
their respective sections.
batteries. Reference the computer
maintenance section for battery
replacement details.
When batteries are initially installed
or replaced, the initialization routine
will start the LCD display blank, then
display "HELLO" on the top row and
"Q9Disp" on the information row for
one second. (See Figure 7)
The LCD will then display "HELLO"
on the top row and "FW Vxx" on the
information version of the software
installed on the display. Example:
"FW V03" indicates software version
3 installed on the display row for one
second. The Vxx will be the (See
Figure 8)
The button usage map on the next
page is useful for understanding
where the various menus are
located within the software
programming and the route to
get to a specific menu. The map
is followed by user instructions
explaining each menu.