Introduction; Before Installation - GPI 03 Series Owner's Manual

Read Me!
For your safety, review the major
warnings and cautions below before
operating your meter.
WARNING
The apparatus enclosure may
contain aluminum and is consid-
ered to constitute a potential risk
of ignition by impact or friction.
Care must be taken into account
during installation and use to
prevent impact or friction.
WARNING
Part of the enclosure is con-
structed from plastic. To prevent
the risk of electrostatic sparking
the plastic surface should only
be cleaned with a damp cloth.
1. This meter is approved to handle
only fluids that are compatible with
the meter's housing material.
WARNING
When metering flammable
liquids, observe precautions
against fire or explosion. Do not
meter in the pressence of any
source of ignition including run-
ning or hot engines, lighted ciga-
rettes, or gas or electric heaters.
WARNING
If handling hazardous liquids,
always follow the manufac-
turer's safety precautions. Wear
protective clothing such as
goggles, gloves and respirators
as instructed.
2. Always dispose of used cleaning
solvents in a safe manner accord-
ing to the solvent manufacturer's
instructions.
3. During meter removal, liquid may
spill. Follow the liquid manufac-
turer's safety precautions to clean
up minor spills.
4. Do not blow compressed air
through the meter.
5. Do not submerge the meter.
6. Do not allow liquids to dry inside
the meter.
7. Do not use a wrench to install
plastic meters. Hand tighten only.
8. For best results, always verify
calibration before use.

INTRODUCTION

Your GPI Electronic Digital Meter
is designed for measuring liquids.
The meter translates pulse data
from the turbine into calibrated
flow units shown on the meter's
readout. Field replace able batteries
provide power.
All meters are tested and factory
calibrated before shipping.
This manual refers to three families of
meters: Low Flow, one inch, and two
inch. To further identify your particular
model, refer to the Specifications
Section at the end of this manual.

BEFORE INSTALLATION

Upon receipt, examine your meter
for visible damage. Remove protec-
tive plugs and caps for a thorough
inspection. If any items are damaged
or missing, contact your distributor.
Make sure the meter model meets
your specific needs. Refer to the
Specifications Section and confirm
the following:
1. Your flowrate is within the limits
of your model.
2. Your liquid is compatible with your
meter's material.
3. Your system's pressure does not
exceed the meter's maxi mum
pressure rating.
3