Seat Leon 5D Owner's Manual page 254

Stop&Go function
The ACC can bring the vehicle to a standstill
(0 km/h) if the vehicle in front stops. With
manual gearboxes you will need to keep the
clutch pedal depressed to allow the car to
come to a complete stop.
The ACC remains active and the message
is displayed on the in-
ACC ready to start
strument cluster for a few seconds. You can
extend or reactivate this warning by pressing
the button or, depending on your vehicle's

equipment, by grabbing the steering wheel.
During this time, the vehicle will move off
again if the vehicle in front moves forwards.
To move off when the message ACC ready
is not longer displayed, once the
to start
vehicle in front has moved off:
Briefly depress the accelerator pedal (and
●
gently lift the clutch pedal on vehicles with
manual gearboxes).
OR: press the button
● 
function steering wheel (only in vehicles with
automatic gearboxes).
The ACC is deactivated while stopped in the
following cases:
If the vehicle stops for several minutes.
●
If a door is opened.
●
252
WARNING
If the message ACC ready to start is dis-
played on the instrument cluster display
and the vehicle in front moves off, your ve-
hicle will move off automatically. In this
case, any obstacles in the road may not be
detected. This may cause serious acci-
dents and injuries.
Always check the road before moving off,
●
and apply the vehicle brakes yourself if
necessary.
ACC system limitations
or on the multi-

Fig. 182
ahead, out of range of the radar sensor.
Driving
Vehicle on a bend. Motorcyclist
 
Vehicle changing lanes.
Fig. 183

hicle turning and another stationary.
The limits of the ACC system mean that it is
not appropriate in all situations
duction on page 249.
SEAT does not recommend using the function
›››
in the following cases :
Heavy rain, snow or fog.
●
When going through tunnels.
●
In sections with roadworks.
●
On routes with curves, e.g. on mountain
●
roads.
On off-road routes.
●
In covered car parks.
●
One ve-

›››
in Intro-