Seat Leon 5D Owner's Manual page 23

amount of the passengers' kinetic energy will
be only absorbed by the mentioned impact.
Even at speeds of 30 km/h (19 mph) to
50 km/h (30 mph), the forces acting on bod-
ies in a collision can easily exceed one tonne
(1000 kg). At greater speed these forces are
even higher.
Vehicle occupants not wearing seat belts are
not "attached" to the vehicle. In a head-on
collision, they will move forward at the same
speed their vehicle was travelling just before
the impact. This example applies not only to
head-on collisions, but to all accidents and
collisions.
Even at low speeds the forces acting on the
body in a collision are so great that it is not
possible to brace oneself with one's hands. In
a frontal collision, unbelted passengers are
thrown forward and will make violent contact
with the steering wheel, dash panel, wind-
screen or whatever else is in the way
›››
Fig. 12.
It is also important for rear passengers to
wear seat belts properly, as they could other-
wise be thrown forward violently through the
vehicle interior in an accident. Passengers in
the rear seats who do not use seat belts en-
danger not only themselves but also the front
›››
occupants Fig. 13.
Seat belts
How to properly adjust your
seat belt
Fastening and unfastening the seat
belt
Insert the latch plate of the seat belt in-
Fig. 14
to the buckle.
Release the seat belt's buckle.
Fig. 15
Properly worn seat belts hold the vehicle oc-
cupants in the position that most protects
them in the event of an accident or sudden
›››
braking .
Fastening the seat belt
Fasten your seat belt before each trip.
Adjust the front seat and headrest correctly
●
›››
page 15.
Engage the seat backrest of the rear seat in
●
›››
an upright position .
Pull the latch plate and place the belt web-
●
bing evenly across your chest and lap. Do
not twist the seat belt when doing so
Engage the latch plate in the buckle of the
●
›››
corresponding seat Fig. 14.
Pull the belt to ensure that the latch plate is
●
securely engaged in the buckle.
Releasing the seat belt
Only unfasten the seat belt when the vehicle
›››
has come to a standstill .
Press the red button on the buckle
●
›››
Fig. 15. The latch plate is released from the
buckle.
Guide the belt back by hand so that it rolls
●
up easily and the trim will not be damaged.
›››
.
»
21