Seat Leon 5D Owner's Manual page 85

hard, the diodes may continue lighting up
and reach the upper zone. This is no
cause for concern, provided the control
lamp does not light up

Warning area. When the engine is work-
C
ing hard, especially at high outside tem-
peratures, the diodes may light up in the
warning area.
The coolant temperature gauge only works
when the ignition is switched on.
In vehicles with digital instrument panel (SEAT
Digital Cockpit) you can select to view the
coolant temperature in the corresponding
›››
menu page 69.
Control and warning lamp
 It lights up red
Do not carry on driving!

Engine coolant level too low, coolant temperature too
high.
 Flashes red
Fault in the engine coolant system.
Stop the vehicle, switch off the engine and
●
let it cool down.
Check the engine coolant level
●
›››
page 328.
Instruments and warning/control lamps
If the warning lamp does not switch off even
●
if the coolant level is correct, request assis-
tance from specialised personnel.
CAUTION
To ensure a long useful life for the engine,
●
avoid high revs, driving at high speed and
making the engine work hard for approxi-
mately the first 15 minutes when the engine
is cold. The phase until the engine is warm
also depends on the outside temperature. If
necessary, use the engine oil temperature*
›››
page 74 as a guide.
Additional lights and other accessories in
●
front of the air inlet reduce the cooling ef-
fect of the coolant. At high outside temper-
atures and high engine loads, there is a risk
of the engine overheating.
The front spoiler also ensures proper dis-
●
tribution of the cooling air when the vehicle
is moving. If the spoiler is damaged this can
reduce the cooling effect, which could
cause the engine to overheat. Seek spe-
cialist assistance.
Service intervals
The service interval display appears on the
instrument cluster screen and in the infotain-
ment system.
There are different versions of instrument
panels and infotainment systems, so the ver-
sions and instructions on the screens may
vary.
SEAT distinguishes between services with en-
gine oil change (e.g. Oil change service) and
services without engine oil change (e.g. In-
spection).
In vehicles with Services established by
time or mileage, the service intervals are al-
ready pre-defined.
In vehicles with LongLife Service, the inter-
vals are determined individually. Thanks to
technological progress, maintenance work
has been greatly reduced. Because of the
technology used by SEAT, with this service
you only need to change the oil when the ve-
hicle so requires. To calculate this variation
(max. 2 years), the vehicle's conditions of use
and individual driving styles are considered.
The advance warning first appears 20 days
before the date established for the corre-
sponding service. The kilometres (miles) re-
maining until the next service are always
rounded up to the nearest 100 km (miles) and
the time is given in complete days. The cur-
rent service message cannot be viewed until
500 km after the last service. Prior to this, on-
ly lines are visible on the display.
Inspection reminder
If a service or an inspection has to be carried
out soon, a service reminder will be dis-
played when the ignition is switched on.
»
83