Dynamic Codes - Enabling/Disabling; Dynamic Codes Activation With Static Codes Deleting; Manager Menu - Tecnosicurezza TechMaster User Instructions

TechMaster
Press to confirm. Then enter the new Manager code and confirm
it. LCD shows:
If the Manager is already installed, press
disabling/deleting/installing it. Then press
Dynamic codes – Enabling/Disabling
WARNING: it is recommended to always perform this operation with door open, to
enable/disable the dynamic codes. Later, dynamic codes can be activated through the red
Dallas key 1971 previously programmed with the software Dyama or DyamaWeb.
Power up the keypad. Enter Master menu. Press
shows:
Press . LCD shows:
Press . The LCD shows:
Press to confirm. LCD shows:

Dynamic codes activation with static codes deleting

WARNING: with this operation, it is possible to delete the static codes for all users and
Manager. Moreover, in depending on the configuration selected, Master static code may be
deleted as well.
Insert the red Dallas key N1971 in the reader. LCD shows:
Enter the activation code generated by the software Dyama or
DyamaWeb and press
Press . LCD shows:
Once terminated, LCD shows:
To re-install the static codes (only for Master and Manager) use the dynamic user
REMOVAL. Later, it is possible to re-install all the other users from the menu Users
management.

Manager menu

Press and then press
Power up the keypad. Enter Manager code (default code 1-2-3-4-5-6).
IU_TechMaster_04_eng
for
to confirm.
. LCD shows:
. LCD shows:
until the LCD
User instructions
OPERATION DONE
DYNAMIC CODES
DYNAMIC CODES
ENABLED/DISABLED
DYNAMIC CODES
ENABLE/DISABLE
?
OPERATION DONE
DYNAMIC CODE
XXX XXX XXX
DELETE ALL THE
STATIC CODES?
OPERATION IN
PROGRESS...
DYNAMIC CODES
ACTIVE
MANAGER MENU
X X X X X X
17 of 27