Remove Locks; Lock Reclosure Mode - Tecnosicurezza TechMaster User Instructions

TechMaster
If the lock selected is already installed, LCD shows:
If the lock selected is not connected with the keypad, LCD shows:
If the lock selected is instead connected with the keypad (but not
installed), LCD shows:
Enter Master code and then Manager code. LCD shows:

Remove Locks

WARNING: it is recommended to perform this operation always with lock open and
connected with the keypad.
Power up the keypad. Access Configuration Menu. LCD shows:
Press until LCD shows:
Press and select the lock to remove.
If the lock selected is connected with the keypad, LCD shows:
Press to confirm. LCD shows:
Enter Master code, LCD shows:
If the lock selected is not installed, LCD shows:
If the lock selected is not connected with the keypad, LCD shows:
Later, LCD shows:
Press to confirm. LCD shows:

Lock reclosure mode

WARNING: this option is only available for motorized locks. To enable it, lock must be
opened.
Power up the keypad. Access Configuration Menu. LCD shows:
Press until the LCD shows:
Press . LCD shows:
Press to select between AUTOMATIC and MANUAL mode.
IU_TechMaster_04_eng
User instructions
LOCK ALREADY
INSTALLED
LOCK X
DOES NOT ANSWER
MASTER CODE
X X X X X X X X
OPERATION DONE
INSTALL
LOCKS
REMOVE
LOCKS
SELECT
LOCK
REMOVE LOCK X?
MASTER CODE
X X X X X X X X
OPERATION DONE
LOCK NOT
INSTALLED
LOCK X
DOES NOT ANSWER
CONTINUE?
OPERATION DONE
INSTALL
LOCKS
LOCK RECLOSURE
MODE
MODE:
AUTOMATIC
23 of 27