TECHNICAL SPECIFICATIONS
Frequency ranges
Switchable channels
Frequencies
Frequency error
RF Power
Antenna connector
RF impedance
Modulation
Nominal deviation
Peak deviation
Spurious emissions
Noise Reduction system
AF bandwidth
Audio input connector
Managing interface
Command buttons & signaling • Pgm
Display
Power supply
Power consumption
Battery life
Temperature range
Dimensions
Weight
T1 band (MHz): 170-230 MHz + 450-696 MHz + 715-744 MHz + 940-960 MHz
T2 band (MHz): 170-230 MHz + 440-696 MHz + 715-744 MHz + 940-960 MHz
(*) Japan 160/460 MHz (optional)
2400 managed in 40 groups ofr 60 frequencies completely user customizable
5 kHz step
The frequencies can be easily PC reprogrammed with USB C, Bluetooth 5 (long
range) or optional UPKmini Programming
< ± 2.5 ppm, in the rated temperature range
switchable Low / Medium / High, typ. 100mW / 300mW / 1W
(*) note: in some countries high power can be disabled, for local norm!
BNC or TNC type female
50 ohm
FM mono, wideband or narrowband IFB (SW selectable)
±40 kHz (wideband), ± 25 kHz (narrowband)
±56 kHz (wideband), ± 35 kHz (narrowband)
< 2 nW (typical = 0.1 pW)
ENS - Wisycom Extended-Sound Optimized (other on request)
50 Hz ÷ 20 KHz (1dB) (Wideband, ARM based, SW switchable)
50 Hz ÷ 15 KHz (1dB) (Narrowband, ARM based, SW switchable)
1 x XLR3-F type (MIC/Line level) for audio input
1 x Jack 3.5mm for audio input/output (sw selectable)
1 x Jack 3.5mm for audio output
USB C, Bluetooth 5 (long range) or optional UPKmini Programming
• Talkback 1
• Talkback 2
• Talkback 3
Transflective color display with high visibility in the sun
standard battery pack RRC2040 or
External = 10 ÷ 18 Vdc (30W max) with Hirose 4-pin connector
440mA @12V / 5.28W in VHF range
450 ÷ 530 mA @12V in UHF range
depending of the frequency and temperature (display off, 1 Watt)
> 5h (power profile & IIP3 trade off) with Lithium RRC2040
-10 ÷ +55 °C
73,1mm x 64,5mm x 21,6mm (H x W x D) with clip
950g (battery included)
RPU500-Tx User Manual
13
Need help?
Do you have a question about the RPU500-Tx and is the answer not in the manual?