Assembly/First Installation; Required Additional Devices; Installation At The Place Of Operation - Atmos Scope Operating Instructions Manual

3.0 Setting up and starting up

3.6 Assembly/First Installation

3.6.1 Required additional devices

• Monitor according to the medical device directive 93/42/EEC.

3.6.2 Installation at the place of operation

Connecting the controller to the mains supply
Ensure that the correct power cable is used for the respective country.
!
24 21
• Connect power cable with power connection at the controller.
• Plug the power cable 24 into a mains socket and thus connect the system to the mains supply.
Connecting the monitor
• Connect BNC video cable 22 with the BNC video output 15 of the controller and composite/CVBS input of the monitor.
Connecting the PC (optional)
The PC has to conform to the medical device directive 93/42/EEC.
Installing the USB Driver on the PC
• Connect the ATMOS Scope to the PC using the USB 2.0 connection cable 23 .
®
• Install the driver from the enclosed CD
ª After the installation is completed the ATMOS Scope will appear as a "USB 2820 Device" in the Device Manager.
®
• Remove software CD from the drive.
• Restart the PC.
PC minimum requirements depend on the used software.
• Follow instructions on the software CD.
Recommendation when using the software on a PC and the availability of a medical grade monitor:
As an alternative to directly connecting the monitor via the BNC video output (composite/CVBS signal) 15 , it is recommended
to connect the medical grade monitor directly to the PC via the PC's external VGA output. The prerequisites for this are proper
connectors on the PC and monitor, as well as the proper connection cables (not included).
10