Table of Contents
Advertisement
178
In the case of an automatic acceptance of the balance data, the weighed-in quantities will be read in from a
memory. If the memory does not contain any balance data, a message will appear (Fig. 50).
Fig. 50
Pressing the Print key will transfer the balance data, too.
Titration will then begin directly after the transfer of the balance data without any further confirmation being
necessary.
The display (Fig. 51) will show the measured value (pH, mV or µA) and the current consumption.
The measured value is displayed in a slightly larger font. A status indication appears.
status indication
measured value
current consumption
Fig. 51
Pressing the <MODE> will cause the titration curve (Fig. 52).
Fig. 52
The consumption in ml will be displayed on the X axis, the Y axis will show the measurement reading.
Scaling of the chart will be done automatically.
Advertisement
Table of Contents
