Tools Required; Rear Case; Fan; Backlight Inverter Board - Tektronix TPS2000 Series Service Manual

Maintenance

Tools Required

6- - 6
To remove and replace the fan, backlight inverter board, or IO board, refer to
Table 6- -2.
Table 6- - 2: Procedures for module replacement by removing the rear case
Remove module
Rear case (Remove for following procedures.)

Fan

Backlight inverter board

IO board

To remove and replace the acquisition board, front panel board, LCD display,
compact flash module, or keypad, refer to Table 6- -3.
Table 6- - 3: Procedures for module replacement by removing the front case
Remove module
Front case (Remove for following procedures.)
Acquisition board
Front panel board
Display module
Compact flash module
Keypad
Use the following tools to remove and replace modules in the oscilloscope:
H Torque-limiting screwdriver, long shank, 8 in-lb (.85 N
T-15 tip
H 16 mm (5/8 inch) deep socket with wide center hole (S
S-K #40818, or equivalent)
H Torque wrench to 40 in-lb (4.5 N
H Screwdriver with 1/4 inch (6.35 mm) flat blade
H Pliers (all-purpose and needle-nose)
TPS2000 Series Digital Storage Oscilloscopes Service Manual
See procedure on
Page 6--7
Page 6--9
Page 6--9. Remove fan first.
Page 6--10
See procedure on
Page 6--11
Page 6--14. Remove IO board first.
Page 6--16
Page 6--17. Remove front panel board first.
Page 6--18. Remove acquisition board first.
Page 6--18
⋅
m) range with Torx®
⋅
K Hand Tool Corp.,
⋅
m)