Tektronix TPS2000 Series Service Manual page 24

Specifications
Table 1- 1: Oscilloscope general characteristics (Cont.)
Horizontal
Sample Rate Range p g
Waveform Interpolation
Record Length
SEC/DIV Range / g
n
Sample Rate and Delay
Time Accuracy
Delta Time Measurement
Accuracy (Full Bandwidth)
Position Range g
Trigger
n n
Trigger Sensitivity, Trigger Sensitivity,
Edge Trigger Type
Trigger Sensitivity, Edge gg y, g
Trigger Type, typical
1
Available only on 4-channel oscilloscopes.
1- 4
TPS2012 and TPS2014 TPS2024
5 S/s to 1 GS/s 5 S/s to 2 GS/s
(sin x)/x
2500 samples for each channel
TPS2012 and TPS2014 TPS2024
5 ns/div to 50 s/div, in a 2.5 ns/div to 50 s/div, in a 1, 2.5, 5 sequence
1, 2.5, 5 sequence
±50 ppm over any ≥1 ms time interval
Conditions Accuracy
±(1 sample interval + 100 ppm × reading + 0.6 ns)
Single-shot, sample
mode
±(1 sample interval + 100 ppm × reading + 0.4 ns)
>16 averages
Sample interval = s/div ÷ 250
2.5 ns/div to 10 ns/div: (- - 4 div × s/div) to 20 ms
25 ns/div to 100 s/div: (- - 4 div × s/div) to 50 ms
250 s/div to 10 s/div: (- - 4 div × s/div) to 50 s
25 s/div to 50s/div: (- - 4 div × s/div) to 250 s
Coupling Sensitivity
DC CH1, CH2, CH3
EXT
EXT/5
EXT/10
Coupling Sensitivity
AC Same as DC-coupled limits from 50 Hz and above
NOISE REJ Reduces the DC-coupled trigger sensitivity by 2 times for greater
than 10 mv/div to 5 V/div
HF REJ Same as the DC-coupled limit from DC to 7 kHz, attenuates
signals above 80 kHz
LF REJ Same as the DC-coupled limits for frequencies above 300 kHz,
attenuates signals below 300 kHz
TPS2000 Series Digital Storage Oscilloscopes Service Manual
1 1
, CH4 1 div from DC to 10 MHz,
1.5 div from 10 MHz to Full BW
1 V from 50 Hz to full BW
5 V from 50 Hz to full BW
10 V from 50Hz to full BW