Dräger Oxylog 3000 plus Pocket Manual page 35

Alarm
!!! Device failure
!!! Display inop
!! etCO high
2
!! etCO low
2
!! Flow measurement
inop
!! High respiratory rate
!! Int. battery charging
inop
!!! Int. battery dis-
charged
Pocket Guide Oxylog 3000 plus
Cause
Technical defect.
Technical defect.
The upper alarm limit for end-
expiratory CO concentration
2
has been exceeded.
The lower alarm limit for end-
expiratory CO concentration
2
has been exceeded.
Measurement hoses for flow
measurement kinked, discon-
nected or leaking.
Flow sensor defective.
Technical defect.
Patient breathes at a high spon-
taneous rate.
The internal battery is not being
charged due to a battery failure.
The internal battery is not being
charged due to a device failure.
The operating time for operation
with the internal battery has
expired and an external power
supply has not been connected.
Remedy
Disconnect the patient from the
device and continue ventilation
without delay using another
ventilator.
Call DrägerService.
Disconnect the patient from the
device and continue ventilation
without delay using another
ventilator.
Call DrägerService.
Check patient condition.
Check alarm limits.
Adjust the alarm limit, if neces-
sary.
Check patient condition.
Check alarm limits
Adjust the alarm limit, if neces-
sary.
Ensure that the flow measure-
ment hoses are connected cor-
rectly.
Replace flow sensor.
Disconnect the patient from the
device and continue ventilation
without delay using another
ventilator.
Call DrägerService.
Check patient condition, check
ventilation pattern, correct
alarm limit RRsp if necessary.
Exchange internal battery.
Call DrägerService.
Continuous ventilation with this
device is only possible with an
external power source.
Call DrägerService.
The ventilator must immedi-
ately be reconnected to a
mains supply, an on-board DC
supply or a fully charged bat-
tery must be installed.
Problem solving
Alarm
Rank
1
38
21
22
37
28
32
2
35