Commissioning Ps Services - Huawei BTS3900 GSM Commissioning Manual

BTS3900(A) GSM
Commissioning Guide
If...
Mobile-originated call succeeds
Mobile-originated call succeeds, and
mobile-terminated call fails
Step 6 Test short message service (SMS) as follows: Use two testing MSs to send SMS messages to
each other, and ensure that all the SMS messages are successfully sent and received.
Step 7 Choose a proper operation procedure based on actual conditions.
If...
Step 3
Step 3
----End

4.5.2 Commissioning PS Services

This describes how to commission PS services by website browsing and file downloading
through an MS. A laptop is required to monitor the commissioning. You need to commission
only the BTS that is configured with the GPRS or EGPRS services.
Prerequisite
l
l
l
l
Issue 02 (2009-04-20)
Then...
1. Repeat
is performed
2. Repeat steps
is not performed Repeat
in other logical cells at the site.
One test MS that supports GSM and PS services is registered with the HLR.
The BTS cell to be checked is configured with the GPRS or EGPRS services.
The logical cell to be checked is activated.
The computer and the BSC work properly.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Commissioning the BTS (Transmission Available)
Then...
1. Check the LEDs and alarms. If an alarm is
generated on the BTS side, clear the alarm.
2. If an alarm is generated on the BSC side,
contact BSC technical support engineers to
handle it.
3. After the fault is rectified, go to
the CS services for another time.
The data configuration on the BSC side is
improper. Contact BSC technical support
engineers for troubleshooting.
Step 3 through
TCHs on the same frequency.
Step 2 through
logical cells at the site.
Step 2, and Step 4
Step 6 to verify the CS services of other
Step 6 to test the CS services in other
through Step 6 to verify the CS services
Step 1 to test
4-25