Table of Contents
Advertisement
3.1
Modular Design
Once the gauge mounting block is built into the pipeline, the sensing unit can be installed and
removed without disassembling the pipework. As a result, the EE741 is also ideal for temporary
measurement at serveral mounting blocks. The sealing plug included in the scope of supply
enable the normal operation of the compressed air system when the sensing unit is removed.
3.1.1
Changing the Pipe Diameter
Upon delivery, the factory setting of the sensing unit corresponds to the pipe diameter as ordered.
The setting must match the gauge mounting block. For use use with a gauge mounting block of
different diameter, the sensing unit setting shall be correspondingly changed, otherwise it would
lead to relevant measurement errors.
Pipe diameter
label
Pipe diameter
label
The pipe diameter setting of the sensing unit can be viewed on the status page of the optional
display and can be changed using the "Pipe diameter" menu, see chapter 6 Display.
The pipe diameter setting can also be viewed and changed using the EE-PCS Product
Configurator Software and via the IO-Link interface.
User Manual EE741 Inline Flow Sensor for Compressed Air and Gases
Fig. 1
Pipe diameter on gauge mounting block
Fig. 2
Pipe diameter on gauge mounting block with flanges
One and the same sensing unit can be used for each of
three pipe diameters:
EE741:
DN15
(1/2")
EE741-N50: DN32
(1-1/4")
The pipe diameter is easily changed via the display
menu or the EE-PCS Product Configurator Software
(available for free download at
configurator).
In the diameters DN32
(1-1/4")
the EE741-N50 can be operated optionally with a gauge
mounting block with flanges.
/ DN20
/ DN25
(3/4")
/ DN40
/ DN50
(1-1/2")
www.epluse.com/
/ DN40
/ DN50
(1-1/2")
(1")
(2")
(2")
7
Advertisement
Table of Contents
