Juniper SRX210 Instructions

Powering On and Powering Off the SRX210 Services Gateway
Powering On the SRX210 Services Gateway
Powering Off the SRX210 Services Gateway
This topic describes the following procedures:
1. Powering On the SRX210 Services Gateway on page 1
2. Powering Off the SRX210 Services Gateway on page 1
3. Resetting the SRX210 Services Gateway on page 2
To power on the services gateway:
Ensure that you have connected the power supply to the device.
1.
Insert the plug of the power supply adapter into an AC power source receptacle.
2.
Turn on the power to the AC power receptacle.
3.
The device starts automatically as the power supply completes its startup sequence.
The Power LED lights up during startup and remains on steadily when the device is
operating normally.
NOTE: After the power supply is turned on, it can take up to 60 seconds for status
indicators such as the Status and Power LEDs to show that the power supply is
functioning normally.
NOTE: It is recommended to issue the CLI command request system power-off when
you want to power off the device immediately after the device is powered on.
You can power off the services gateway in one of the following ways:
Graceful shutdown
gracefully shutting down the operating system and then powers itself off.
Immediate shutdown
seconds. The device immediately powers itself off without shutting down the
operating system.
NOTE: Do not press the Power button while the device is shutting down.
WARNING: Use the graceful shutdown method to halt, power off, or reboot the
services gateway. Use the immediate shutdown method as a last resort to recover
Press and release the Power button. The device begins
Press the Power button and hold it for more than ten
Powering On and Powering Off the SRX210 Services Gateway
1