RGBlink VENUS X2 User Manual page 58

5. Communication Software Guideline
Software Operation
Source 1 will be switched to signal 5, click source 1, then click ―TAKE‖ icon
, the signal will be switched to the corresponding monitor. Connect
the signal to the corresponding output after setting.
Presentation Mode
Click the ―Presentation Mode‖, and pop-up window as follows:
Click ―OK‖, the system will synchronize the data, and it will finish about 5
seconds later, click ―OK‖, it will enter the interface as follows:
Select the preview mode, and select multiview or splice multiview, then select
the preview image according to actual need. User can select max three
outputs in one output card.
The connection diagram area will show the corresponding splice guidance
figure, as shown in the figure below:
VENUS X2 User Manual 58