RGBlink VENUS X2 User Manual page 48

5. Communication Software Guideline
Software Operation
Auto tile: User can enable or disable the auto tile function by clicking the auto
on the right side of the interface. If select auto tile ―ON', the
tile shortcut
layer will automatically snap to the output grid when move the layer to it within
the threshold value.
Monitor Size and Position Setting: Move the mouse to the lower right brink
of the monitor, and press the left key of the mouse. Move the mouse to the
suitable position and release the mouse. But this method can only adjust the
size and location roughly, if an accurate adjustment is needed, select the
monitor, and set the X, Y, width and height in the bottom of the interface.
Monitor Size changed equivalently: Select any monitor, for example, select
monitor 1, and adjust the size. Click this monitor, then press button C and don't
let go, select the monitor that will set, the size of the selected monitor will be
changed to the same size of monitor 1, as shown in the figure below:
Rotation: Select the monitor, and set the rotation as 0° , 90° , 180° and 270° in
the bottom of the interface. Click ―OK‖ to confirm. As shown in the figure
below:
VENUS X2 User Manual 48