RGBlink VENUS X2 User Manual page 49

5. Communication Software Guideline
Software Operation
User can also right click the monitor to rotate.
Output Area Size Setting: Move the mouse to the output area and slide the
mouse wheel, the output area size can be zoom in and out.
Layer Setting
New Layer: In output screen zone of controlling software, press the left mouse
key and drag on the intended output screen to cover the whole current screen.
And the below interface will be displayed. A layer can also be opened by
double clicking the left signal source to be shown on the window.
Adjust Layer: Two ways can change the size and location of the opened
layer:
a. Drag the opened layer by mouse. The details are: move the mouse to the
brink of the opened layer, when the mouse shows‖<—>‖, press the left key of
the mouse and drag the window to a suitable size and then release the mouse.
Or move the mouse to the lower right of the opened layer, press the left key of
the mouse and drag the window to a suitable size and then release the mouse.
Move the mouse to the opened layer and press the left key of the mouse and
move the mouse, then the layer will be moved, release the mouse when
moved to the suitable location. But this method can only adjust the size and
location roughly, if an accurate adjustment is needed, the second method can
VENUS X2 User Manual 49