Operation; Preface - HNC Electric SV-E3 Series Instruction Manual

Note 1) About I/O status, "C" indicates the internal output circuit contact and external contact is close, while "O" means open.

8. Operation

8.1 Preface

8.1.1 Preface
This product can drive the motor by 5 operation modes of combination of control mode and command mode.
This chapter describes the operation method of different operation modes.
■ Position control mode (Pulse position command input)
1) Wiring for user I/O (CN1) connector
The following three kinds of signals can be input in position control mode.
- Differential input
- 24V open collector input
- 5V open collector input
2) The setting of basic parameter
3) Test run
■ Speed control mode(Analog speed command input)
1) Wiring for user I/O (CN1) connector
2) The setting of basic parameter
3) Test run
■ Speed control mode(Internal speed command)
1) Wiring for user I/O (CN1) connector
2) The setting of basic parameter
3) Test run
89