Operation Mode Change - HNC Electric SV-E3 Series Instruction Manual

SET
UP
UP (long-press)
DOWN
DOWN(long-press)
SHIFT
SHIFT+DOWN
SHIFT+UP
SHIFT+S, long press for
2s or more

5.3 Operation mode change

The operation procedures of changing operation mode by set panel are shown below.
Turn on the control power to the drive, the set panel will show
Speed feedback(motor speed r/min). Press the MODE button once again, it comes to the Status display mode and shows
「dP_St 」. When press the MODE button again, it will come to Alarm display mode, Parameter setting mode, Auto tuning
mode, Parameter saving mode in turn. Press the MODE button again, it returns to the Status display mode. Press the SET
button to come to the selection of operation mode.
Item or value select/confirm
Selected value (flicker) increase
Selected value (flicker) increase rapidly
Selected value(flicker) decrease
Selected value(flicker) decrease rapidly
Selected cursor moves left.
The screen lock/unlock
Reset the servo drive
The servo drive enabling ON/OFF
. Press the MODE button once, it will show
40