Servo Off→On - HNC Electric SV-E3 Series Instruction Manual

Note 1) About I/O status, "C" indicates the internal output circuit contact or external contact is close, while "O" means open.
Note 2) After the parameters are cleared, 5sec is needed for T1 because of parameter initialization.
Note 3) When /ERROR and main circuit power supply PRDY is ON, S-RDY is ON.
7.2 Servo OFF→ON
Note 1) About I/O status, "C" indicates the internal output circuit contact or external contact is close, while "O" means open.
Note 2) The servo can be not ON when motor speed is less than 30rpm..
Note 3) T1 can be set in parameter No.238.0. (Initial value 4msec, value range: 0 to 500msec)
84