Appendix; Appendix 1 Recommended Wire/Cable; Appendix 2 Sv-E3 Positioner Function - HNC Electric SV-E3 Series Instruction Manual

The drive and motor do not match.

Appendix

Appendix 1 Recommended wire/cable

Cable name
Motor power cable (750W or less)
Motor power cable (1KW or less)
200VAC input (750W or less)
FG cable Note 2)
200VAC input (1KW or more)
FG cable Note 2)
Encoder
User I/O
Regenerative resistor connection
Brake
Main circuit DC power (750W or
less) Note 2)
Main circuit DC power (1KW or
more) Note 2)
Communication between the drives
Note 2)
The length of cable depends on the actual situation.
Note 1) AWG16 cable can be used for 1kW motor.
Note 2)For multi-axial drives
Appendix 2 SV- E3 positioner function
1. Overview
This product has the positioning function of using point table.
Preset the data by the point table in the drive and set the Point No. to be started through I/O input by the upper controller. After
inputting the start signal, the positioning will be done according to the selected Point No.
2. Basic setting [2.1 User I/O connector (CN1) wiring]
Table 2.1 User I/O connector CN1 connector pins arrangements
Name Symbol
User I/O CN1
If the drive and motor do not match, clear the EEPROM parameter and
change the motor models.
AWG UL
18 2517
14 Note 1) 2501
18 1015
14 Note 1) 1015
Power：22 20276
Signal：24
26 1007
18 1015
18 2517
18 1015
14 Note 1) 1015
28 20539
Pin No. Signal name
1 24V
161
Heat-resistance Remark
105℃
105℃
105℃
105℃
80℃ Max.20m for shielded cable of 5P(10
cores) (when using shielded
twisted-pair cable)
80℃ Shielded twisted-pair cable
Recommended length: 50m or less
105℃
105℃ 1P(2 cores)
105℃
105℃
80℃ Ribbon cable 10 cores
Accessories ((2.54mm spacing)
Contents
Drive control power supply 24V input