Wiring Explanation For Servo Motor And Drive; Wiring Diagram - HNC Electric SV-E3 Series Instruction Manual

4. Wiring explanation for servo motor and drive

4.1 Wiring diagram

4.1.1 Wiring diagram
[Points for correct wiring]
※ 24VDC and 200VAC input (main circuit) power supply should be wired from the same 200VAC main power supply.
※ Do not access switch between 24VDC power supply and drive. If you need switch, put it on the 200VAC cable of 24VDC
input power supply.
※ A twisted-pair shielded cable should be used when I/O cable length is over 50cm.
※ The encoder cable should be less than 20m.
31