Parameter Setting Mode - HNC Electric SV-E3 Series Instruction Manual

5.6 Parameter setting mode

The operating procedures of parameter setting are shown below.
When pressing "MODE" button three times from the initial display, 「P」 will be displayed on the leftmost of LCD and it comes
to parameter setting mode. 3 digits, a decimal point, 1 digit and a blank will be displayed in turn on the right side of 「P」 . The
combination of 3 digits, a decimal point and1 digit constitute the parameter No. Press UP or DOWN button to the parameter
No. to be set and press SET button to display the parameter value on the servo drive.
For the details of parameter number, refer to [Section 6 Parameter Description]. When 「r」 is displayed on the rightmost side ,
it means the drive power supply must be restarted after saving the parameter. For the methods of parameter saving, refer to
「Section 5.8 Parameter saving mode」
Restart the power supply to the drive No need to restart the power supply to the drive
The operating procedures of parameter change are shown below. If parameters displayed, the rightmost LCD will flash and it
comes to the state that parameters can be input.
On the condition that parameter is beyond the range from -99999 to 99999(only for No.087.0 position deviation error
detection value), as said in [Status display mode] and [Signed 6-digit or more parameter on LCD], 5 digits can be displayed
every time. The flashing digit can be changed and press "SHIFT" to select the digit to be changed (flash). Parameter value can
be changed by pressing "UP" or "DOWN" button. Press "SET" button to set the parameter on the drive and the digit will no
longer flicker. If you do not want to change the parameter value and just confirm it, press "MODE" button to return. If the drive
is powered off, the parameter value will return to the state before change.
In order to save the parameter after change in the EEPROM of drive, refer to [Section 5.8 Parameter saving mode] for details.
Figure 5.6.1
50