Status Display Mode - HNC Electric SV-E3 Series Instruction Manual

5.4 Status display mode

The operation procedures of Status display mode are shown below.
Press the "MODE" button twice from the beginning to get into status display mode and 「dP_St」 displays. Model code and
serial number can be checked in this mode.
Status mark number will be displayed on the right side of「St_」 when press "SET" button. As for the meaning of status mark,
refer to 「Status display list」 or 「Status description」. The status mark number will display alternatively when press "UP"
or "DOWN" button. When status displays, press "SET" button to display its value.
Model code and serial number will be displayed after the status when press "UP" or "DOWN" button. The status mark number
will display alternatively. Model code will be displayed in 「Pt_[AAA]」 and serial number displayed on 「Ps_[AAA]」. In the
display _[AAA], 「Jot」indicates the motor, 「drv」indicates the drive and 「Enc」indicates the encoder.
Mark number
Figure 5.4.1
Table 5.4.1 Status display list
Status
Parallel I/O status
Display the bit number of assigned parallel IO.
For details, refer to [About parallel I/O status]
Temperature at the control part[℃].
Temperature at the control part of servo drive.
42